English

Lamp warning message

The following Lamp warning displays will remind you to change the lamp. The

lamp hour information is also available in the Information > Lamp time menu.

Message

Status

 

 

The lamp has been in operation for 2000 hours. Install a new lamp for optimal performance.

Replacing the lamp

CAUTION: HOT SURFACE! The lamp may be very hot after use. Before

replacing the lamp, turn off the projector, unplug the power cord, and allow the projector to cool for at least 45 minutes.

The lamp unit contains mercury. Disposal of mercury may be regulated due to environmental considerations. Dispose of the used lamp unit by the approved method for your area. Contact your local authorities or www.eiae.org (USA only).

A lamp is consumable supplies. If used for extended periods, images will appear dark, and the lamp could burn out. This is characteristic of a lamp, and is not malfunction. (The lifetime of the lamp depends on condition of use.) If this happens, replace it with a new one.

WARNING

If the projector is mounted on the ceiling, ask your Toshiba dealership to replace the lamp. Replacing the lamp at a high site by yourself may cause you to drop down, thus resulting in injury.

When replacing, always use lamp “TLPLW7” (sold separately).

CAUTION

If you have been using the projector, the lamp will be very hot, and may cause burn injuries. Wait for the lamp to cool (for at least 45 minutes) before replacing it.

If the lamp should break, please handle with care to avoid injury due to broken pieces and contact your dealer for repair service.

38 Additional Information

Page 38
Image 38
Toshiba TDP-P75 owner manual Lamp warning message, Replacing the lamp