Toshiba TDP-P75 owner manual Troubleshooting

English

Troubleshooting

Problem	Cause							Remedy
		Plug the power cord into the AC inlet on
	There is no power from the power	the projector, and plug the power cord
		into to a power outlet. If the power outlet
The projector	cord.	has a switch, make sure it is switched
		on.		p. 26
does not turn
on.	Attempting to turn the projector on	Wait until the cooling-down process is
	again during the cooling process.	completed.
	The lamp cover is not securely	Correctly attach the lamp cover.
	attached.
	The video source is not turned on	Turn the video source on and check that
		the signal cable is connected correctly.
	or connected correctly.		p. 23
No picture.	The projector is not correctly
	connected to the input source	Check the connection.							p. 23
	device.
	The input signal has not been	Select the correct input signal with the
		INPUT buttons on the remote control or
	correctly selected.
		INPUT on the projector.								p. 28
Image is	The connection cables are not	Correctly connect the cables to the
	securely connected to the
unstable.		appropriate terminals.
	projector or the signal source.
	The projection lens is not	Adjust the focus of the lens using the
	correctly focused.	focus ring.					p. 27
Picture is	The projector and the screen are	Adjust the projection angle and direction
		as well as the height of this unit if
blurred.	not aligned properly.
		necessary.						p. 27
	The lens cap is still attached to	Remove the lens cap.
	the lens
	The batteries are out of power.	Replace both of the batteries with new
Remote control		ones.			p. 19
	There is an obstacle between the
does not work		Remove the obstacle.
correctly	remote control and the projector.
	You are too far away from the	Stand within 5 meters (16.4 feet) of the
	projector.	projector.				p. 19

Troubleshooting 41