Xerox Network Laser Printers manual Macintosh Troubleshooting Step-by-Step, Sheet” page

Macintosh 1

Troubleshooting

Step-by-Step 2

3

4

5

6

7

Macintosh Troubleshooting

Verify that the printer is plugged in, turned on, and connected to an active network.

Verify cable connection to the printer from the EtherTalk network. (BNC connections should have the locking pins of the plug snapped into the slots of the jack. RJ45 connections should be fully inserted and the locking clip engaged.)

Verify that the printer is receiving network traffic by monitoring the LEDs on the back of the printer. When the printer is connected to a functioning network receiving traffic, its link LED will be green, and its orange traffic LED will be flashing rapidly.

From the Control Panel, verify that EtherTalk is enabled. If not, enable it in the Control Panel (see page 5-5) and reset the printer.

Print a Configuration sheet and verify that EtherTalk is enabled. Refer to the section “Print the Configuration

Sheet” (page 2-21).

From the Configuration Sheet, verify the Zone. If you have multiple zones on your network, be certain your printer is set to advertise in the desired zone.

If you are still unable to print, contact Xerox Customer Service.

Chapter 5: Macintosh Network Setup ❖ 5-9