Xerox Network Laser Printers Setting from Windows Operating Systems, Set An IP Address, Adapter

Set An IP Address

Setting from Windows Operating Systems

Perform these steps to enter the IP Address using ARP and telnet from a Windows OS. Some DocuPrint network printers do not support telnet. For these printers, enter the IP address from the Control Panel as described in the previous section.

Telnet only works if the device is on the same subnet as the host (i.e. computer or workstation).

1	Open an MS-DOS session
2	2 Ping a known IP address on the network by typing ping
	x.x.x.x, where x.x.x.x is the IP address of a device on the
	network.
	This step is required
3	Create a static ARP entry by typing the following
	command: arp -s x.x.x.x aa-aa-aa-aa-aa-aa [Enter] where
	x.x.x.x is the IP address you are assigning and
	aa-aa-aa-aa-aa-aa is the Ethernet Address
	The Ethernet Address can be found on the
	Configuration Sheet. If you are using a
	XeroxCentreDirect External Print Server (External
	Ethernet Adapter) the Ethernet Address can be
	found on a label located on the bottom of the
	Adapter.
4	Type arp -a [Enter]. A list should appear that shows the
	host that was pinged and the new entry

Chapter 2: Connecting to Your Network ❖ 2-9