| Quick Step (OS/2 Warp Server V 4.0) |
Troubleshooting | 1 Check cables/drops. Are the LEDs active? |
| 2 Print Settings. Check Enabled=ON, IPADDRESS=dhcp/ |
| bootp/static (make sure the IP Address resolution is set |
| properly. Use DHCP if your network uses a DHCP server to |
| assign IP addresses. Use RARP/BOOTP if your network uses |
| BOOTP to assign IP addresses, and use STATIC if you wish |
| to assign a specific IP address). |
| You may set a Static IP Address form the control |
| panel if your printer has one. If you are connected |
| to a network with a Xerox CentreDirect External |
| Print Server (External Ethernet Adapter) then use |
| ARP or NBMON Utility to set a Static IP Address. |
3
4
5
6
Printer Properties - Using LPD Output Port.
Watch LPRPORTD Screen - Is there Activity? In printer input light processing?
It may take a few prints before initial quality responds. Print
Refer to the DocuPrint System Administrator Guide for additional information.
Chapter 7: OS/2 Network Setup ❖