![5 Type Telnet x.x.x.x[Enter].](/images/new-backgrounds/107261/10726147x1.webp)
Set An IP Address
5 Type Telnet x.x.x.x[Enter].
Make sure that telnet is enabled on the External Ethernet Adapter by examining the position of the DIP switches which are located on the rear panel. D1 should be in the up position and D2 should be in the down position. If you change the position of the switches, make sure you cycle the power off and on before proceeding.
6
7
8
When the telnet window appears, type ! [Enter] (exclamation point) and then yes [Enter] to enter monitor mode.
Type I [Enter] to enter the IP address. Enter the desired IP address.
Reboot the network interface by typing R[Enter].
When you reboot the network interface, you will lose your telnet connection. Close the telnet session window and open a new connection after the network interface has rebooted.
When the Xerox CentreDirect External Print Server (External Ethernet Adapter) acquires an IP Address, the SYS LED blinks once per second. If the IP Address is not set the SYSLED blinks 5 times per second.
