Xerox Network Laser Printers Setting from Windows or Unix Operating Systems, T Enter, E Enter

Setting DEFAULT GATEWAY at the Control Panel

Setting from Windows or Unix Operating Systems

Perform these steps to enter the Default Gateway using telnet from a Windows or Unix OS. Some DocuPrint network printers do not support telnet. For these printers, enter the Default Gateway from the Control Panel as described in the previous section.

Telnet only works if the device is on the same subnet as the host (i.e. computer or workstation).

1	Open a telnet session.
	Windows: Open a MS-DOS window, type telnet
	x.x.x.x[Enter], where x.x.x.x is the IP address
	Unix: Type telnet hostname in a shell
2	Type ![Enter] and then yes[Enter] to enter monitor mode.
3	Select the Network Protocols Menu, N [Enter].
4	Select the TCP/IP Options Menu,	T [Enter].
5	Select the Engine Options Menu,	E [Enter].
6	Type y [Enter].
7	Select Default router (gateway), g [Enter].
8	Enter the new Default Gateway address, [Enter].
9	Select X [Enter] to exit this menu or end the telnet
	session.

2-20 ❖ DocuPrint Technical Information Guide