Xerox Network Laser Printers Display/set ethernet options, Flash firmware load enable/disable

Display/set ethernet options:

Monitor Menu:

Command [?,C,D,E,F,H,I,L,N,P,Q,R,S,Z,*,+] --> E

(note: Aux port is now set in the sockets section of the Network protocols menu)

Link test is enabled

Link test

1(disabled)

2(enabled)

<enter> (don't change/continue)

Link test is now enabled

Flash firmware load enable/disable:

Display/set IP address:

Command [?,C,D,E,F,H,I,L,N,P,Q,R,S,Z,*,+] --> F

Flash load is enabled.

Ver 1.56, dt 8/25/1998 14:48, (seqNum=1)

Flash load currently is enabled. Disable, yes or no (y or n)?:n

Command [?,C,D,E,F,H,I,L,N,P,Q,R,S,Z,*,+] --> I

current IP address: not set. ( 13.231.38.195 set by DHCP ).

Enter new IP address (<cr> for no change):

Appendix A: Telnet and NBMON command mode options ❖ A-5