Toshiba Tecra A3/S2 - page 121

4 Replacement Procedures 4.6 Optical Drive
4-14 Tecra A3/S2 Series Maintenance Manual
Reassembling the Optical Drive
To reassemble an optical drive, follow the steps below and refer to the figure in the preceding
section.
1. Position the optical drive bracket plate to the rear panel of optical drive.
2. Secure the optical drive bracket plate with two black M2.5×8 screws.
3. Secure the Base case with five M2.5x3 screws.
4. Install the optical drive module into the bay and secure with one M2.5x3 screw.