COMPLETING INSTALLATION

After you have connected all the necessary cables, you can push the CD-ROM completely into the slot. There are 12 screw holes on the XM-6401B that are used to mount the CD-ROM into your computer. The screw length should not exceed 3±0.5mm (measured from out- side surface of side or bottom of CD-ROM to tip of screw). Replace the computer’s cover, and replace all outer screws

Mounting Screw

M3

Mounting frame of host computer

Surface of side or bottom of CD-ROM drive

3 ±0.5mm

Mounting CD-ROM

SOFTWARE

In order for your computer to recognize the CD-ROM, you must in- stall a CD-ROM software driver. If you do not have this software driver, contact the manufacturer of your SCSI host adapter card. Use the instructions that came with your software to install the CD-ROM software driver.

TOSHIBA XM-6401B/TXM6401F1 CD-ROM Drive 11

Page 16
Image 16
Toshiba (T)XM6401B/F1 instruction manual Completing Installation, Mounting CD-ROM, Software