Toshiba W-804, W-808 Basic Playback, Adjusting the tracking, DNR (Digital Noise Reduction) (For W-808only), Rewinding / Fast-forwarding, Press, Notes, Notes, DnR On:, PLAYBACK

PLAYBACK

Playback

This VCR can also play back a tape recorded in S-VHS or S-VHS ET format. This section explains the basic playback operation.

Preparation

•Select the video channel (3 or 4) or video input mode on the TV.•Press VCR to set the remote control operating the VCR.

1 2 3

4 5 6

7 8 9

0 100

	PLAY/x2
REW	ENTER	FF
	ENTER
	STOP
VCR Plus+		DNR
A.SELECT	REMAIN	COUNT
	COUNTER	RESET
POWER	CH DOWN	CH UP

VCR

CH/TR K

REW

DNR

Basic Playback

1	Load a recorded cassette.			POWER
	Power is turned on.
	If the cassette has no safety tab,
	playback starts automatically.

2	Press	PLAY/x2 to start playback.		POWER
				S P	VCR
					VCR
					DT


3	To stop playback, press		STOP.

Rewinding / Fast-forwarding

Press REW or FF in the stop mode.

PLAYBACK

Adjusting the tracking

When playback starts, the VCR
automatically adjusts the tracking for clear
pictures and sound (Digital Auto Tracking).
The “DT” indicator blinks during the
adjusting.
If the VCR cannot locate the best possible		CH/TRK to
tracking point,	hold down one of

adjust the tracking manually.•To resume the digital auto tracking, holddown both CHANNEL on the VCR simultaneously for about 2 seconds.

Notes

•During the adjusting, the playback picture and sound may be distorted.•The digital auto tracking is activated only in the playback mode.•To reset the manual tracking point to the center,

press both CHANNEL on the VCR simultaneously for not longer than 1 second.

•The noise on the screen may not be completely eliminated depending on the tape used, especially when the tape was recorded on another VCR.

DNR (Digital Noise Reduction) (For W-808 only)

The noise reduction function of this VCR is based

on a digital signals system utilizing memory. It is effective in the playback of noisy tapes as well as S-VIDEO and RF in video signal.

Furthermore the CSE (Color Signal Enhancement) circuit, which is included in the system, compensates for color signal weakness and gives the best possible color. Thanks to this circuit color distortion is reduced and a sharp picture is played back.

Press DNR repeatedly to select the following:

DnR On:	Usually set to “O	n ”.
	The “D n R O	n ” will appear on the TV
	screen and you can view the picture
DnR OFF:	with less noise.
DnR OFF:	This function will not work.

Notes

•The DNR playback is available only in the playback mode.

•Depending on the recorded picture, for example too vivid or too noisy, you may not notice a reduction in the noise.

•The noise reduction may not work on pictures recorded from special equipment such as TV game machines or computers.

•The picture sharpness can be changed by full

screen OSD setting. (See page 16.)	(Continued)