TP-Link TD-W8980 manual RIP Settings, To add a new entry, follow the instructions below

TD-W8980N600 Wireless Dual Band Gigabit ADSL2+ Modem Router User Guide

To add a new entry, follow the instructions below.

1.Click the Add New button in Figure 4-61,and you will see the screen as shown in Figure 4-62.

Figure 4-62

2.Enter the following data:

¾Destination IPv6 Address: The Destination IPv6 Address is the address of the network or host that you want to assign to a static route.

¾Prefix Length: The prefix length of the destination IPv6 address.

¾Gateway: Here you should type the IPv6 Gateway address correctly, and the option for Interface will adopt the default IPv6 Gateway address for the IPv6 Static Route.

¾Interface: Select the Interface name from the drop-down list, or else, the default Interface will be adopted for the IPv6 Static Route.

¾Status: Select Enabled or Disabled from the drop-down list.

3.Click Save to save your settings.

To modify or delete an existing entry:

1.Find the desired entry in the table.

2.Click Edit as desired on the Edit column.

Click the Enable/ Disabled Selected button to make selected entries enabled/ disabled.

Click the Delete Selected button to delete selected entries.

4.11.4 RIP Settings

Choose “Route Settings”Æ“RIP Settings”, you can see the RIP (Routing Information Protocol) screen which allows you to configure the RIP.

72