TP-Link TL-SG3424P manual System IP,  IP Config

Note:

1.When the DST is disabled, the predefined mode, recurring mode and date mode cannot be configured.

2.When the DST is enabled, the default daylight saving time is of Europe in predefined mode.

4.1.5 System IP

Each device in the network possesses a unique IP Address. You can log on to the Web management page to operate the switch using this IP Address. The switch supports three modes to obtain an IP address: Static IP, DHCP and BOOTP. The IP address obtained using a new mode will replace the original IP address. On this page you can configure the system IP of the switch.

Choose the menu System →System Info →System IP to load the following page.

Figure 4-7 System IP

The following entries are displayed on this screen:

IP Config

MAC Address: Displays MAC Address of the switch.

IP Address Mode: Select the mode to obtain IP Address for the switch.

Static IP: When this option is selected, you should enter IP Address, Subnet Mask and Default Gateway manually.

DHCP: When this option is selected, the switch will obtain network parameters from the DHCP Server.

BOOTP: When this option is selected, the switch will obtain network parameters from the BOOTP Server.

IP Address:Enter the system IP of the switch. The default system IP is 192.168.0.1 and you can change it appropriate to your needs.

Subnet Mask:Enter the subnet mask of the switch.

Default Gateway: Enter the default gateway of the switch.

Note:

1.Changing the IP address to a different IP segment will interrupt the network communication, so please keep the new IP address in the same IP segment with the local network.

2.The switch only possesses an IP address. The IP address configured will replace the original IP address.

18