TP-Link TL-SG3424P manual Lacp Config,  LAG Config, LAG will delete this LAG

Choose the menu Switching → LAG → Static LAG to load the following page.

Figure 5-8 Static LAG Config

The following entries are displayed on this screen:

LAG Config

Group Number:	Select a Group Number for the LAG.
Description:	Give a description to the LAG for identification.
 LAG Table
Member Port:	Select the port as the LAG member. Clearing all the ports of
	the LAG will delete this LAG.

Tips:

1.The LAG can be deleted by clearing its all member ports.

2.A port can only be added to a LAG. If a port is the member of a LAG or is dynamically aggregated as the LACP member, the port number will be displayed in gray and cannot be selected.

5.2.3 LACP Config

LACP (Link Aggregation Control Protocol) is defined in IEEE802.3ad and enables the dynamic link aggregation and disaggregation by exchanging LACP packets with its partner. The switch can dynamically group similarly configured ports into a single logical link, which will highly extend the bandwidth and flexibly balance the load.

With the LACP feature enabled, the port will notify its partner of the system priority, system MAC, port priority, port number and operation key (operation key is determined by the physical properties of the port, upper layer protocol and admin key). The device with higher priority will lead the aggregation and disaggregation. System priority and system MAC decide the priority of the device. The smaller the system priority, the higher the priority of the device is. With the same system priority, the device owning the smaller system MAC has the higher priority. The device with the higher priority will choose the ports to be aggregated based on the port priority, port number and operation key. Only the ports with the same operation key can be selected into an aggregation

53