XT302C Deluxe Programmable
Heat-Cool Thermostat
INSTALLER'S GUIDE
APPLICATION
The XT302C Deluxe Programmable
Table 1. Description of XT302C.
Model | System | Changeover | System Selection | Fan Selection | Comments |
|
|
|
|
|
|
XT302C | Multistage | Automatic | System and fan selections are done by | ||
|
|
|
|
| keyboard. |
|
|
|
|
|
|
RECYCLING NOTICE
If this thermostat is replacing a thermostat that contains mercury in a sealed tube, do not place your old thermostat in the trash.
Contact your local waste management authority for instructions regarding recycling and the proper disposal of the old thermostat.
Wallplate Installation
Position wallplate horizontally on the wall or on a 2 in. x 4 in. wiring box.
1.Position and level the wallplate for appearance only (the thermostat will function properly even when
not level).
INSTALLATION
When Installing this Thermostat...
1.Read these instructions carefully. Failure to follow the instructions can damage the product or cause a hazardous condition.
2.Check the ratings given in the instructions and on the product to make sure the product is suitable for your application.
3.Installer must be a trained, experienced service technician.
4.After completing installation, use these instructions to check out the product operation.
NO
YES
NO
NO
5FEET
[1.5 METERS]
M17106
Location
Install the thermostat about 5 ft (1.5m) above the floor in an area with good air circulation at average temperature. See Fig. 1. Avoid installing the thermostat where it can be affected by the following:
•Drafts, or dead spots behind doors and in corners.
•Hot or cold air from ducts.
•Radiant heat from sun or appliances.
•Concealed pipes and chimneys.
•Unheated (uncooled) areas such as an outside wall behind the thermostat.
Fig. 1. Typical location of thermostat.
® U.S. Registered Trademark |
|
Copyright © American Standard Inc. 1999 |
