Transition Networks C4TEF10XX-10X specifications S4TEF10xx-10x, Stand-Alone Media Converter

User’s Guide

S4TEF10xx-10x

Stand-Alone Media Converter

•RS-232 to Fiber

•(4) T1/E1 to Fiber

The S4TEF10xx-10x media converter can extend signals from an RS-232 data port and up to four (4) T1/E1 network ports over fiber.

The RS-232 and T1/E1 interfaces are independent of each other and the signals from these ports can be sent over the fiber interface simultaneously.

The S4TEF10xx-10x is designed to be installed in pairs. For example, install one S4TEF1011-100 as the local media converter and another S4TEF1011-100 as the remote media converter.

All S4TEF10xx-10x models have the following copper connectors:

Connector Type	Number	Description
RS-232	one (1)	6-pin, DIN serial, 3.2 m (10 ft.)*
T1/E1	four (4)	RJ-48

The various fiber connectors are available on separate models. Both duplex and single mode fiber optic converters are available:

Part Number	Duplex Fiber-Optic - 100Base-FX
S4TEF1011-100	ST, 1300 nm multimode, 2 km (1.2 miles)*
S4TEF1013-100	SC, 1300 nm multimode, 2 km (1.2 miles)*
S4TEF1014-100	SC, 1310 nm single mode, 20 km (12.4 miles)*
S4TEF1015-100	SC, 1310 nm single mode, 40 km (24.8 miles)*
S4TEF1016-100	SC, 1310 nm single mode, 60 km (37.2 miles)*
S4TEF1017-100	SC, 1550 nm single mode, 80 km (49.7 miles)*
S4TEF1018-100	MT-RJ, 1300 nm multimode, 2 km (1.2 miles)*
S4TEF1029-10x	(single mode, single fiber models are listed on page 2)

*Typical maximum cable distance. Actual distance is dependent upon the physical characteristics of the network.

The chassis version of the media converter is C4TEF10xx-10x. For more information, see the user’s guide on-line at: www.transition.com.

Installation	.2
Operation	10
Cable Specifications	12
Technical Specifications	14
Troubleshooting	15
Compliance Information	19