
S4TEF10xx-10x
Installation -- Continued
Switch Set #2 - Serial Options
6 - not in use
Installation -- Continued
Hardware/Software Jumper
The hardware/software jumper is inside the media converter housing and is located near the back end of the upper circuit board.
7 - not in use
8 - not in use
9 - not in use
6 7 8 9
switches 6, 7, 8, & 9 are not in use
Hardware The media converter mode is determined by
the switch settings (see pages 3 - 6).
Software The media converter mode is determined by the
S |
|
|
|
| H |
| Software Mode | ||||
S |
|
|
|
| H |
|
|
|
| ||
|
|
|
| ||
|
|
|
|
|
|
Hardware Mode
10 - Fiber Loop-Back
up - Disabled fiber loop-back.
down - Enabled fiber loop-back.
The
10
up |
Disables
down
Enables
To set the jumper:
1.Using a small screwdriver, remove the four (4) screws that secure the cover and carefully remove the cover from the media converter.
2.Locate the hardware/software jumper.
3. Using small
4.Carefully replace the cover on the media converter and replace the four (4) screws that secure the cover to the media converter.
hardware/software jumper
Power the Media Converter
1.Connect the barrel connector on the power adapter to the media converter’s power port (located on the back of the media converter).
2.Connect the power adapter plug to AC power.
3.Verify that the media converter is powered by observing the illuminated LED power indicator light.
NOTE: For DC power, consult the user’s guide for the Transition Networks
6 | techsupport@transition.com | 7 |