JVC HR-XVC33U manual 14 EN, Check the contents, Situate the unit Connect the unit to TV

14 EN INSTALLING YOUR NEW UNIT

Basic Connections

Antenna or Cable

Coaxial cable
Flat feeder
	Matching transformer
	(not supplied)
AC Outlet	AUDIO
	OUTPUT
AC Power Cord	VIDEO OUTPUT

Back of unit	VHF/UHF
	IN
Audio/video cable	VHF/UHF OUT
(not supplied)
To Audio/video	RF cable
input connectors	(supplied)

To 75 ohm

Terminal

TV

It’s essential that your unit be properly connected.

THESE STEPS MUST BE COMPLETED BEFORE ANY VIDEO OPERATION CAN BE PERFORMED.

A Check the contents.

Make sure the package contains all of the accessories listed in “SPECIFICATIONS” on page 89.

B Situate the unit.

C Connect the unit to TV.

The connection method you use depends on the type of TV you have.

RF Connection

8To connect to a TV with NO AV input connectors —

ADisconnect the TV antenna from the TV.

BConnect the TV antenna cable to the VHF/UHF IN connector on the rear panel of the unit.

CConnect the supplied RF cable between the VHF/UHF OUT connector on the rear panel of the unit and the TV’s antenna terminal.

AV Connection

8To connect to a TV with AV input connectors —

AConnect the antenna, unit and TV as per “RF Connection”.

BConnect an optional audio/video cable between the AUDIO/VIDEO OUTPUT connectors on the rear panel of the unit and the TV’s audio/video input

connectors.

●Set your TV to AV mode.

●For switching the TV’s mode, refer to the instruction manual of your television.

●To obtain high-quality pictures, you can also use the S-VIDEO

connection or Component Video Connection. (DVD deck only) ( pg. 15, 16)

D Connect the unit to power source.

Plug the end of the AC power cord into an AC outlet. This unit performs Plug & Play Set automatically. ( pg. 17)

●The clock and tuner channels will automatically be set when the antenna is connected and when the AC power cord is first connected to an AC outlet. (If “AUTO” and the channel indicator are displayed on the front display panel before the unit is powered on, the clock and tuner channels are being set automatically. Wait for the time to be displayed on the front display panel before turning on the unit.)

E Set the VCR channel.

The VCR channel is the channel on which you can watch the picture from the unit on the TV when only using RF connection.

With RF connection, set the VCR channel to “3 CH” or “4 CH”.

●The VCR channel is preset to “3 CH”. Set to “4 CH” if the Channel 3 is used for broadcasting in your area.

With AV connection, set the VCR channel to “– CH” (off). To set the VCR channel, perform the following steps:

APress POWER (1) to turn off the unit, then press STOP (8) on the unit for more than 5 seconds. “3 CH” appears on the front display panel.

BPress CH +/– on the Remote to select “3 CH”, “4 CH” or “– CH” (off), then press OK.

Place the unit on a stable, horizontal surface.