JVC HR-XVC33U manual Maintaining brightness of dark and bright

EN 47

VFP function

— Adjusting the picture quality

The VFP (Video Fine Processor) function enables you to adjust the picture character according to the type of programing, picture tone or personal preference.

NOTE:

Before you start operation;

The VFP setting screen disappears if no operations are done for more than about 10 seconds. If the setting screen disappears before you finish, start from step 1 again.

1Access the VFP setting menu.

4Select the parameter.

Press rt repeatedly to select a parameter you want to adjust, then press OK.

●Adjust gradually and confirm picture appearance results are as preferred.

GAMMA	Controls brightness of neutral tints while
(–4 to +4):	maintaining brightness of dark and bright
	portions.
BRIGHTNESS	Controls screen brightness.
(–16 to +16):
CONTRAST	Controls screen contrast.
(–16 to +16):
SATURATION	Controls screen color depth.
(–16 to +16):
TINT	Controls screen tint.

Press DVD PICTURE during playback.

●The current setting appears on the TV screen.

NORMAL

GAMMA	+0
BRIGHTNESS	+0
CONTRAST	+0
SATURATION	+0
TINT	+0
SHARPNESS	+3
Y DELAY	+0

(–16 to +16):
SHARPNESS	Controls screen sharpness.
(+0 to +3):
Y DELAY	Controls screen color gap.
(–2 to +2):

2Select the VFP mode.

Press w e repeatedly.

●Each time you press w e, the VFP mode changes as follows:

NORMAL]CINEMA]USER 1]USER 2](Back to the beginning)

NORMAL: Select this normally.

CINEMA: Suitable for movie.

USER 1/ You can adjust parameters that affect picture

USER 2: appearance and store settings. Go to step 3.

NOTE:

You cannot adjust the parameters of “NORMAL” and “CINEMA”.

To adjust picture appearance manually

●VFP menu disappears and the following pop-up window appears on the TV screen.

GAMMA +0

GAMMA +0

5Adjust the parameter.

Press rt repeatedly to change the setting, then press

OK.

●The current VFP settings appear again.

6Adjust the other parameters.

Repeat steps 4 and 5 to adjust other parameters.

To return to the normal screen

3Access USER menu.

Press w e repeatedly to select “USER 1” or “USER 2”.

USER 1

GAMMA	+0
BRIGHTNESS	+0
CONTRAST	+0
SATURATION	+0
TINT	+0
SHARPNESS	+3
Y DELAY	+0

Press DVD PICTURE.

To activate your setting

Press DVD PICTURE, then press w e repeatedly to select “USER 1” or “USER 2” that you have changed the parameters.