JVC HR-XVC33U manual Plug & Play Set

INITIAL SETTINGS EN 17

Plug & Play Set

Auto Clock Set/Auto Tuner Set

ATTENTION

●If you use a cable box, Plug&Play will not function; set the clock and tuner channels separately. ( pg. 24 – 27)

●Depending on areas or reception conditions, the unit may not receive the Auto clock setting data from the PBS channel. If this function is taking a considerable amount of time, it may be necessary to perform the Semiauto or Manual Clock Set procedure.

This unit sets the clock and tuner channels automatically when AC power cord is first connected to an AC outlet. The antenna cable must be connected for the Plug & Play setting.

The time and date can be set automatically by the clock setting data transmitted from one of the regular TV broadcast channels. We call this TV channel the “host channel” and it is a PBS channel in your area.

A Perform Plug & Play setup.

Connect the antenna cable to the unit. ( pg. 14) Then connect the AC power cord to an AC outlet. Do not turn on the unit.

The clock and tuner channels will be set automatically.

NOTES:

● Auto Clock Set is performed first.

“AUTO” blinks on the front display panel during Auto Clock Set.

● Auto Channel Set is performed next. Auto Channel Set scans all the channels that are receivable by your unit. During Auto Channel Set, the channel numbers are displayed as they are scanned and set.

● When Plug & Play setting has been complete successfully, the correct clock time is displayed. If you perform Plug & Play setting successfully, there is no need to perform “Clock Set” ( pg. 24) and “Tuner Set” ( pg. 26). If, however, you want to add or delete channels, refer to “Manual Channel Set” ( pg. 27).

During Initial Auto Clock Set	During Auto Channel Set	Plug&Play Completed
“AUTO” blinks.	The channel numbers are displayed as they are	The current time is displayed.
	scanned and set.

* If an incorrect clock time or “– –:– –” appears on the front display panel, see “What to do if Plug & Play setting failed” below.

INFORMATION

●If “AUTO CLOCK” is set to “ON” ( pg. 25), the clock will be adjusted automatically by the host channel every hour (except 11:00 PM, midnight, 1:00 AM and 2:00 AM) using the incoming PBS channel clock setting data. (This automatic clock

adjustment can only be performed when the unit is turned off. The clock will be adjusted just on these hours — on the time displayed on the front display panel, not on the actual real time.) The default setting of “AUTO CLOCK” is “ON”. ( pg. 25)

●If the memory backup fails, because a power outage occurs or because the AC power cord is unplugged, Plug & Play will be performed when power is restored to the unit.

What to do if Plug & Play setting failed

●If an incorrect time is displayed on the front display panel, you may be receiving the clock setting data of a PBS channel from an adjacent time zone, or an incorrect PBS channel from a cable TV system. In this case, perform “Semiauto Clock Set” ( pg. 25) or “Manual Clock Set” ( pg. 25).

●If “– –:– –” appears on the front display panel, your antenna cable may not be connected to the unit or there may not be a Host PBS signal available in your area. Ensure that the antenna cable is connected correctly. Then turn on and off the unit; the Plug &

Play setting will be automatically reactivated. If Plug & Play setting is not performed though the antenna cable is connected correctly, perform “Manual Clock Set” ( pg. 25) and “Auto Channel Set” ( pg. 26) or “Manual Channel Set” ( pg. 27).