JVC HR-XVC33U manual 40 EN

40 EN OPERATIONS ON VCR DECK (cont.)

ATTENTION

If there is a conflict in the timer schedule and one program overlaps with another, only the parts shown below in gray will be recorded.

Pattern 1: The program with the lower program number will be recorded.

Program 1	CH10
Program 2
	CH40	Not recorded

Pattern 2: The program starting earlier will be recorded.

Program 1 CH10

Program 2 CH40 Not recorded

Pattern 3: The program starting earlier will be recorded, followed by the remaining portion of the other program.

Program 1 CH10

Program 2 CH40

Not recorded

When programs overlap each other

If “PROGRAM NOT COMPLETED PROGRAM OVERLAP” appears, you have another program overlapping the program you have just made.

The Program Check screen appears and conflicting programs will start blinking.

Example: Program 1 (you have just made) and Program 4 overlap each other.

A Confirm the overlapping programs.

Overlapping programs blink on the TV screen.

B Select the program to modify.

Press rt, then press OK or e.

●You can only select one of the overlapping programs.

NOTE:

If you do not mind this overlap, press PROG. to finish the timer program setting. The program with the lower program number will be recorded and the other one will not be recorded correctly. If no changes are made for approximately 1 minute, the unit will return to the normal screen.

C Cancel or change program setting.

To cancel a program, press CANCEL when the Program screen you do not want is shown. “PROGRAM COMPLETED” appears on the TV screen for about

5 seconds, then the normal screen appears.

To change a program, press the appropriate button: START +/–, STOP +/–, DATE +/–, CH +/–, DAILY (number key “8”), WEEKLY (number key “9”) and/or SP/ EP when the Program screen on which you want to make changes is shown, then press OK. “PROGRAM COMPLETED” appears on the TV screen for about

5 seconds, then the normal screen appears.

NOTE:

If the overlap is not yet solved, or another overlap occurs with the timer program setting after making the last correction on a program, the conflicting programs will be shown on the Program Check screen again. Repeat the above steps again until the overlap is solved.