JVC HR-XVC33U manual Advantages of S-VHS video recorders, Video cable, AV mode

EN 69

Edit To Or From

Another Video

Recorder

A
TV receiver	Player	Your unit
	S-Video cable
	Audio/video cable	Audio/video
		cable
AV mode
	Another recorder
	Recorder
B Your unit	Recorder	TV receiver
		AV mode
S-Video cable
	Audio/video
	cable
		Audio/video
		cable
Another recorder
Player

Advantages of S-VHS video recorders

You can edit from VHS to S-VHS, S-VHS to VHS, or, from S-VHS to S-VHS.

●From VHS to S-VHS: Record VHS playback signals in the S-VHS mode. Although the picture quality is inherently limited by that of the original, the edited tape has better picture quality than those made by VHS-to-VHS editing.

●From S-VHS to VHS: Because the picture quality of the source material is very high, the edited tape has better picture quality than those made by VHS-to-VHS editing.

●From S-VHS to S-VHS: All signals will be transferred with minimum degradation.

You can use your unit as the source player or as the recording deck.

Slide the TV/VCR/DVD switch to the right.

A Make connections.

AWhen using your unit as the source player ...

... connect its AUDIO/VIDEO OUTPUT connectors to the audio/video input connectors on another recorder.

BWhen using your unit as the recording deck ...

... connect its AUDIO/VIDEO INPUT connectors to the audio/video output connectors on another recorder.

●If connecting a unit with an S-VIDEO input/output connector, it is recommended to use the supplied S-Video cable to minimize picture degradation while editing.

B Select the VCR deck.

On the unit

Press VCR/DVD repeatedly so that the VCR indicator lights up.

On the Remote

Press VCR so that the VCR indicator lights up.

C Set the input mode of recording deck.

With this video unit, press AUX (number key “0”) and/or CH to select “L-1”.

●When using S VIDEO connector, set “REAR AUX INPUT” to “S-VIDEO”. ( pg. 79)

●When using VIDEO connector, set “REAR AUX INPUT” to “VIDEO”. ( pg. 79)

●When using another recorder as the recording deck, refer to its instruction manual.

D Set the edit mode.

See “PICTURE CONTROL” on page 76.

E Engage the Record Pause mode of the recording deck.

Locate the point where you start recording, then engage the Record Pause mode.

F Start the source player.

Engage the Play mode of the source player.

G Start the recording deck.

Engage the Record mode of the recording deck.

NOTES:

●All necessary cables can be obtained from your dealer.

●When you select “EDIT” to dub tapes in step D, be sure to select “AUTO” (or “NORM” when “VIDEO CALIBRATION” is set to “OFF”) after you finish dubbing the tapes.

●When you use this unit as the source player for editing, be sure to set “SUPERIMPOSE” to “OFF” before starting. ( pg. 77)