Pioneer VSA-AX10 Multi Ch In Select, 2Use the 2 3 buttons to select the input, Press ENTER button

Advanced Setup

MULTI CH IN SELECT

Use this feature to adjust the type of output for audio signals which were input from multichannel inputs. You can set the output of the audio signal in regards to the surround speakers and the surround back speak- ers, which were input from 5.1 channel surround sound soundtrack.

There are three OUTPUT MODE settings:

THROUGH: The sound is output directly how it was input.

S =SB: The audio signal which was input into the surround channels will be output from the surround back speakers only.

S=S & SB: The audio signal which was input into the surround channel is output from the surround speakers and from the surround back speakers. This setting will give the most realistic home theater experience in the MULTI CH IN SELECT setting.

STANDBY/ON

ENTER

5˜∞˜2˜3˜ENTER buttons

1 3.Expert Setup

[1. OSD Adjustment ]

[2. Bass Peak Level]

[3. D-Range Control]

[4. Multi-Ch In Select ]

[5. Function Rename]

[Return]

Follow steps 1-4 on page 82, if necessary, to get to the starting point mentioned here.

1MULTI-CH IN SELECT should be selected if it isn’t use the 5∞ buttons to select it. Press ENTER.

2Use the 2 3 buttons to select the input

channel: 7 CH IN, 6 CH IN or 5 CH IN

You do this to establish the proper downmixing of sur- round back channels. If you connected two surround back inputs choose 7 CH IN. If you connected one surround back input choose 6 CH IN. And if you connected no surround back inputs choose 5 CH IN.

2	3.4. Multi-Ch	In	Select
	Input Channels
		[	5ch	in	]
	Output Mode
		[Through]
	[Return]
3,	3.4. Multi-Ch	In	Select
4,5	Input Channels
		[5ch		in]
	Output Mode
		[	S	SB		]

[Return]

3Use the 5∞ buttons to select the

OUTPUT MODE you want.

See the OUTPUT MODE explanations above. For details on speaker placement in this mode see page 95.

4Use the 2 3 buttons to choose a type of output mode: THROUGH, S =SB, S=S & SB.

5Use the 5∞ buttons to select RETURN.

Press ENTER button.

Your MULTI CH IN SELECT output set. Next, move on to FUNCTION RENAME, if necessary.

If you want to change a setting before proceeding

Start over from step one.

memo

•If you want to setup either S=SB, S=S & SB, you need to connect all 7.1 CH speak- ers, including the surround back left and right speakers.

•If you use only one surround back speaker hook it up to the left surround back speaker terminal.

6If you want to continue EXPERT SETUP use the 5∞ buttons to select the next setup and press ENTER.

7If you want to finish EXPERT SETUP use the 5∞ buttons to select RETURN and press ENTER. Then use the 5∞ buttons to select EXIT and press

ENTER.

86

En