Pioneer VSA-AX10 operating instructions Advanced Setup, Assigning the Digital Input

Advanced Setup

Assigning the Digital Input

If you did not hook up your digital equipment in accordance with the default settings for the digital inputs (see p.25) you need to complete the procedure below. You have to do this in order to tell the amplifier what digital equipment is hooked up to which terminal so the buttons on the remote correspond to what you have hooked up.

					2
1		Amplifier		MAIN	SUB	SETUP
						REMOTE
	AMP		BASS/			CD
		TONE
			ATREBLE
						CD-R/
	DVD/LD
						TAPE1
				EFFECT/
	VCR1
		DISPLAY	VIDEO	CH SEL.		TUNER
	/DVR
		DIMMER	SELECT
	VCR2		SPEAKER		INPUT	VIDEO
		STATUS		LOUDNESS
3	VCR3		A/B		ATT.	SAT
	TV	SYSTEM		TAPE 2	SIGNAL	TV
		SETUP		MONITOR	SELECT	CONTROL

4	System Setup
	[ Auto Surround Setup ]
	[			]
		1.	Input Assign
	[2.		Surround Setup]
	[3.		Expert Setup]
	[4. THX Audio Setup]

1Turn on the amplifier and your TV, press the AMP on the remote control.

2Press the SUB button on the remote control.

3Press the SYSTEM SETUP button.

4Looking at the on-screen display on your TV, use the 5∞ buttons to select INPUT ASSIGN. Press the ENTER button.

	[Exit]
5	1.Input Assign

[ 1.Digital-In Select ]

[ 2.C' nent Video In ]

[Return]

6	1.1. Digital-In	Select
	Digital-1	[ DVD/LD ]
	Digital-2	[	TV	]
	Digital-3	[	CD	]
	Digital-4	[	SAT	]
	Digital-5	[	VCR1	]
	Digital-6	[	VCR2	]
	Digital-7	[	CD-R	]
	RF IN	[ DVD/LD ]

[Return]

memo

•The possible digital inputs that can be assigned are: DVD/LD, TV, SAT, VCR 1/DVR, VCR 2, VCR 3, CD, CD-R/TAPE 1 (except for a 2 RF input which doesn't include CD, CD-R/TAPE 1).

•If you assign a digital input to a certain function (for example DVD/LD) then any digital inputs pre- viously assigned to that function will automati- cally be set to OFF. This is because one func- tion cannot be assigned to two different places (except for the RF IN).

5DIGITAL-IN SELECT should be selected, if not use the 5∞ buttons to select it. Press the ENTER button.

6Use the 5∞ buttons to move through the different digital input settings and use the 2 3 buttons to select the component that you hooked up to that digital in.

7If you're not sure which component is connected to which digital in, look on the back of the amplifier and check the cables you connected.

8When you're finished use the 5∞ buttons to select RETURN and press

ENTER.

You will leave the "Assigning the Digital Inputs" mode.

9Use the 5∞ buttons to select

RETURN and press ENTER, again. Then, use the 5∞ buttons to select

EXIT and press ENTER.

80

En