Before You Start

The Touch Pen & Lock

The touch pen is located in the back right-hand corner of the remote control. Take it out by sliding your finger along the bottom right edge of the remote control and then grasping the pen with thumb and forefinger.

The lock switch is located in the top right-hand corner on the back of the remote control. When this switch is set to LOCK you can’t use the buttons on the remote control. This is helpful to prevent you from mistakenly pushing a button. For normal use keep the switch set in USE.

Lock Switch

Touch pen

Remote Control Cushions

Apply the cushions to the feet of the remote control as shown in the diagram right.

Operating range of remote control unit

The area in which you can use the remote control to operate the VSA-AX10 is fairly large. To use, point the remote control toward the remote sensor on the front panel of this unit while within the range shown below.

Remote control may not function properly if:

30

• There are obstacles between the remote control and

the remote sensor.

30

Direct sunlight or fluorescent light is shining onto the

 

 

remote sensor.

 

The amplifier located near a device emitting infrared

7m

 

rays.

 

 

Operated simultaneously with another remote control which uses infrared rays.

PREPARATION

Opening the Front Panel

To open the front panel push gently on the lower third of the panel with your finger.

7

En

Page 7
Image 7
Pioneer VSA-AX10 operating instructions Opening the Front Panel, Touch Pen & Lock, Remote Control Cushions