
Basic Operation
DUAL MONO Setting and playback
The dual mono setting can only be used when listening to Dolby Digital or homemade discs that have dual mono software encoded in them. Dual mono software usually is used to put two different mono recordings with one soundtrack on one DVD. With this setting you can choose which channel in the dual mono setting you want to listen to. Remember this setting is only applicable if you are using Dolby Digital software with dual mono and want to isolate one of the channels therein. Otherwise, just ignore this function.
1 |
1Press the LISTENING CH SELECT button for more than five seconds to put the amplifier in DUAL MONO
mode.
Hold down the LISTENING CH SELECT button to cycle through the different DUAL MONO settings. When you find the one you want release the button.
memo • The default setting is DUAL ch1.
• You can only use this function with Dolby Digital sources that have this function
•When a DUAL MONO source is being used the Ò & Â indicators flash. Then, if you select DUAL ch1, for example, the Ò indicator will light.
DUAL : ch1 DUAL : ch2
DUAL: ch1/ch2
The different settings are: DUAL ch1, where you only hear channel 1; DUAL ch2, where you only hear channel 2; and DUAL ch1/ch2, where you hear both channels, but independently from different speakers.
Input Attenuator
The input attenuator lowers the input level of an analog signal when it is too strong, causing distortion in the sound.
Amplifier | MAIN | SUB |
| |
TONE | BASS/ |
|
|
|
TREBLE |
|
|
| |
|
|
|
| |
|
| EFFECT/ |
| |
DISPLAY | VIDEO | CH SEL. |
| |
DIMMER | SELECT |
|
| 1 |
STATUS | SPEAKER | LOUDNESS | INPUT | |
SYSTEM | A/B | TAPE 2 | ATT. | |
| SIGNAL |
| ||
SETUP |
| MONITOR | SELECT |
|
Tape 2 Monitor
1Use the INPUT ATT button on the AMP SUB screen to lower the analog input level.
BASIC
If you connect a cassette deck with a record monitor function (a
Amplifier | MAIN | SUB | |
TONE | BASS/ |
|
|
TREBLE |
|
| |
|
|
| |
|
| EFFECT/ | |
DISPLAY | VIDEO | CH SEL. | |
DIMMER | SELECT |
|
|
STATUS | SPEAKER | LOUDNESS | INPUT |
| A/B |
| ATT. |
SYSTEM |
| TAPE 2 | SIGNAL |
SETUP |
| MONITOR | SELECT |
1
1Use the TAPE 2 MONITOR button on the AMP SUB screen to listen to the component hooked up to the TAPE 2 MONITOR jacks.
57
En