JVC HR-XVC33U manual To Component Video Input connectors

16 EN INSTALLING YOUR NEW UNIT (cont.)

Component Video Connection

(DVD deck only)

ATTENTION

Be sure to connect the unit’s VIDEO OUTPUT (DVD/ VCR) connector to the TV’s VIDEO input connector.

Antenna or Cable
Coaxial cable
Flat feeder
	Matching transformer
	(not supplied)
AC outlet	COMPONENT	AUDIO
	VIDEO OUT	OUTPUT
AC power cord	VIDEO OUTPUT

Back of unit		VHF/UHF
		IN
Component	Audio/Video	VHF/UHF
Video cable	cable	OUT
(not supplied)	(not supplied)
		RF cable
		(supplied)

8To connect to a TV with component video input connectors . . .

A Connect the unit to TV.

AConnect the aerial, unit and TV as per “AV Connection”. ( pg. 14)

BConnect the unit’s COMPONENT VIDEO OUT connectors to the TV’s component video input connectors.

B Connect the unit to power source.

Plug the end of the AC power cord into an AC outlet. This unit performs Plug & Play Set automatically. ( pg. 17)

●The clock and tuner channels will automatically be set when the antenna is connected and when the AC power cord is first connected to an AC outlet. (If “AUTO” and the channel indicator are displayed on the front display panel before the unit is powered on, the clock and tuner channels are being set automatically. Wait for the time to be displayed on the front display panel before turning on the unit.)

C Set the VCR channel to off.

Before performing the following steps:

●Make sure there is no cassette inserted in the unit.

●Make sure the unit is turned on, then press VCR/ DVD on the unit or VCR on the Remote so that the VCR indicator lights up.

APress POWER (1) to turn off the unit, then press STOP (8) on the unit for more than 5 seconds. “3 CH” appears on the front display panel.

BPress CH +/– on the Remote to select “– CH” (off), then press OK.

NOTES:

●You can obtain high-quality component video pictures when you play back discs on the DVD deck.

●If your TV is not stereo-capable, use the unit’s AUDIO OUTPUT (DVD/VCR) connectors to connect to an audio amplifier for Hi-Fi stereo sound reproduction.

●To operate the unit with your TV using the Component Video connection, set your TV to its AV mode. You can also use the

TV/VCR button on the unit’s Remote to set your TV to the AV mode. ( pg. 73)

●For switching the TV’s mode, refer to the instruction manual of your television.

To Component Video Input connectors

To 75 ohm

Terminal

TV