![Operation -- Continued](/images/new-backgrounds/111378/1113787x1.webp)
Operation -- Continued
Pause Control
The Pause feature can improve network performance by allowing one end of the link to signal the other to discontinue frame transmission for a set period of time to relieve buffer congestion.
NOTE: If the Pause feature is present on ALL network devices attached to the media converter(s), enable the Pause feature on the media converter(s). Otherwise, disable the Pause feature
Cable Specifications -- continued
Extended temperature models -- continued
1310Tx/1550Rx nm single mode | ||
1550Tx/1310Rx nm single mode | ||
min: | ||
min: | max: | |
Link Budget: | 19.0 dB |
|
Standard models
Link Pass-Through
The Link
Fiber Optic Transmitter Power:
Fiber Optic Receiver Sensitivity:
Link Budget:
Fiber Optic Transmitter Power:
Fiber Optic Receiver Sensitivity:
Link Budget:
1300 nm multimode |
|
min: | max: |
min: | max: |
11.0 dB |
|
1300 nm multimode |
|
min: | max: |
min: | max: |
11.0 dB |
|
Device
1
local converter sends a loss signal over the fiber link
Local | 2 | Remote |
Media |
| Media |
Converter |
| Converter |
|
3
Fiber Optic Transmitter Power:
Fiber Optic Receiver Sensitivity:
Link Budget:
1300 nm multimode |
|
min: | max: |
min: | max: |
14.5 dB |
|
original fault on the Ethernet copper link
4 |
fiber link is still valid |
remote converter disables the Ethernet copper link
Link Budget:
1310 nm single mode | |
min: | max: |
min: | max: |
16.0 dB |
|
Far-End Fault
When a fault occurs on an incoming fiber link (1), the media converter transmits a
|
|
|
|
| original fault |
|
|
|
|
|
|
|
|
|
| on the fiber link |
|
|
|
|
|
|
| Media |
| 1 | Media |
|
|
| ||
|
|
|
|
|
|
| ||||
| Device | 4 | Converter A |
| 2 | Converter B | 3 | Device |
| |
|
|
|
|
|
|
|
| |||
| media converter A |
|
|
|
| media converter B | ||||
disables the copper link | signal is sent |
| disables the copper link | |||||||
|
|
|
|
|
|
|
|
|
|
|
Link Budget:
Link Budget:
Link Budget:
1310 nm single mode | |
min: | max: |
min: | max: |
17.3 dB |
|
1310 nm single mode | |
min: | max: |
min: | max: |
26.0 dB |
|
1310 nm single mode
1550 nm single mode
min: | max: 0.0 dBm |
min: | max: |
29.0 dB |
|
The fiber optic transmitters on this device meet Class I Laser safety requirements per
6 | techsupport@transition.com | 7 |