MSAP2000 AAMS User’s Guide

If your FTP client does not allow you to have a destination filename different than the source, you will need to rename them as the MSAP2000 AAMS only recognizes “config-0” and “ras”. Be sure you keep unaltered copies of the files for later use.

The following table is a summary. Please note that the internal filename refers to the filename on the MSAP2000 AAMS and the external filename refers to the filename not on the MSAP2000 AAMS, that is, on your computer, local network or FTP site and so the name (but not the extension) may vary. After uploading new firmware, use the sys version command to confirm that you have uploaded the correct firmware version.

Table 67 File Name Conventions

FILE TYPE

INTERNAL NAME

EXTERNAL NAME

DESCRIPTION

Configuration File

config-0

*.dat

This is the configuration filename for the

 

 

 

MSAP2000 AAMS.

Firmware

ras

*.bin

This is the generic name for the ZyNOS

 

 

 

firmware on the MSAP2000 AAMS.

 

 

 

 

31.3 Editable Configuration File

The configuration file can be downloaded as a plain-text (ASCII) file. Edits to the configuration can be made to this file before it is uploaded again to the MSAP2000 AAMS.

Note: You can change the “.dat” file to a “.txt” file and still upload it to the

MSAP2000 AAMS.

31.3.1Editable Configuration File Backup

Configure your system, and then use FTP to backup the plain-text configuration file onto your computer. Do the following to backup the configuration file:

Use an FTP client to connect to the MSAP2000 AAMS.

C:\> ftp <MSAP2000 AAMS IP address>

Enter the User name (just press [ENTER]).

User: [ENTER]

Enter the management password (1234 by default).

Password: 1234

230 Logged in

Use get to transfer the configuration file to the computer. The configuration file on the system

(that you want to backup to the computer) is named config-0.

ftp> get config-0

238

Page 238
Image 238
ZyXEL Communications MSAP2000 manual Editable Configuration File Backup, Enter the User name just press Enter