MSAP2000 AAMS User’s Guide

Figure 9 Basic Setting IP Setup Menu

5Use this screen to change the IP address, subnet mask, and default gateway IP address for your network. Apply the settings. If you change the MSAP2000 AAMS’s IP address, you must use the new IP address if you want to access the web configurator again.

Figure 10 IP setup

6Skip to step 15 if you have your subscribers use VPI 0 and VCI 33 (the default for all of the ADSL ports). Otherwise, use the following steps to change the VPI and VCI settings for all of the ADSL ports.

First you will delete the default virtual channel from all of the ADSL ports (you cannot edit it).

Adding another virtual channel without deleting the default virtual channel is not recommended since you cannot set the new channel to be the port's super channel. The super channel can forward frames belonging to multiple VLAN groups (that are not assigned to other channels). A channel that is not the super channel can only forward frames with a single VLAN ID (that is configured on that channel). The MSAP2000 AAMS would drop any frames received from the subscriber that are tagged with another VLAN ID.

Then you will configure a new virtual channel for a port and copy it to the other ADSL ports

7 Under Basic Setting, click xDSL Port Setup.

35

Page 35
Image 35
ZyXEL Communications MSAP2000 manual Under Basic Setting, click xDSL Port Setup