ZyXEL Communications MSAP2000 manual Atu-C, Atu-R

MSAP2000 AAMS User’s Guide

Figure 34 Alarm Profile

The following table describes the fields in this screen.

Table 20 Alarm Profile

LABEL	DESCRIPTION
Port Profile	Click Port Profile to open the Port Profile screen. Use the Port Profile
	screen to configure profiles of ADSL port settings (such as the transfer rate,
	interleave delay and signal to noise ratio settings).
VC Profile	Click VC Profile to open the VC Profile screen where you can configure
	virtual channel profiles.
IGMP Filter Profile	Click IGMP Filter Profile to open the IGMP Filter Profile screen where you
	can configure IGMP multicast filter profiles.
Name	Type a name to identify the alarm profile (you cannot change the name of the
	DEFVAL profile). You can use up to 31 ASCII characters; spaces are not allowed.
Add	Click Add to save your changes to the volatile memory to avoid losing
	these changes if it is turned off or loses power, so use the Config Save link on
	the navigation panel to save your changes to the non-volatile memory when
	you are done configuring.
Cancel	Click Cancel to start configuring the screen again.
Threshold	Specify limits for the individual performance counters. The MSAP2000 AAMS
	sends an alarm tram and generates a syslog entry when one of these
	thresholds is exceeded. A value of 0 disables the alarm threshold.
ATU-C	These fields are for traffic coming from the subscriber’s device.
ATU-R	These fields are for traffic going from the MSAP2000 AAMS.
15 Min LOF(sec)	This field sets the limit for the number of Loss Of Frame seconds that are
	permitted to occur within 15 minutes.

75