ZyXEL Communications General Setup, MSAP2000 Aams User’s Guide System Information, Max, Min

MSAP2000 AAMS User’s Guide

Table 9	System Information (continued)
LABEL			DESCRIPTION
Temperature			Each temperature sensor can detect and report the temperature. Temperature
		sensor 1 is near the ADSL line driver. Temperature sensor 2 is near the ADSL
		chipset. Temperature sensor 3 is near the central processing unit.
Current		This shows the current temperature at this sensor.
MAX		This field displays the maximum temperature measured at this sensor.
MIN		This field displays the minimum temperature measured at this sensor.
Average		This field displays the average temperature measured at this sensor.
Threshold (Low)		This field displays the lowest temperature limit at this sensor.
Threshold (Hi)		This field displays the highest temperature limit at this sensor.
Status		This field displays Normal for temperatures below the threshold and Over
		for those above.
Voltage		The power supply for each voltage has a sensor that can detect and report
		the voltage.
Current		This is the current voltage reading.
MAX		This field displays the maximum voltage measured at this point.
MIN		This field displays the minimum voltage measured at this point.
Average		This field displays the average voltage measured at this sensor.
Threshold (Low)		This field displays the lowest voltage limit at this sensor.
Threshold (Hi)		This field displays the highest voltage limit at this sensor.
Status		Normal indicates that the voltage is within an acceptable operating range at
		this point; otherwise Abnormal is displayed.
Use this section of the screen to configure the hardware monitor threshold settings.
New threshold		Configure new threshold settings in the fields below and click Apply to use them.
Temperature (Hi)		Use these fields to configure the highest temperature limit at each sensor
Temperature			Use these fields to configure the lowest temperature limit at each sensor.
(Low)
Volt. (Hi)			Use these fields to configure the highest voltage limit at each sensor.
Volt. (Low)			Use these fields to configure the lowest voltage limit at each sensor.
Poll Interval(s)			The text box displays how often (in seconds) this screen refreshes. You
			may change the refresh interval by typing a new number in the text box
			and then clicking Set Interval.
Stop			Click Stop to halt statistic polling.

6.3 General Setup

Click Basic Setting and General Setup in the navigation panel to display the screen as shown.

50