Transition Networks Connecting 100BASE-TX Cable, Installing StackMaster TX12 in 19-inch Rack

Connecting 100BASE-TX Cable

To connect 100BASE-TX Cable to StackMaster TX12 RJ-45 connectors:

1.Locate or build 100BASE-TX cables with the following characteristics:

•803.2 compliant (See page 15)

•cable length less than 100 meters

•male RJ-45 plug connectors installed at both ends of cable.

2.Connect male RJ-45 plug connector at one end of 100BASE- TX cable to StackMaster TX12 RJ-45 jack connector.

3.Connect male RJ-45 plug connector at other end of 100BASE- TX cable to terminal device RJ-45 jack connector.

Installing StackMaster TX12 in 19-inch Rack

NOTE: Optionally, the StackMaster TX12 can be installed on a table or other flat, stable surface.

NOTE: The StackMaster TX12 is shipped with attached brackets for standard 19-inch rack installation. Rackmount screws and clip nuts are NOT provided.

To install the StackMaster TX12 in 19-inch rack:

Up to 100 meters

1. Locate four (4) screws (and clip nuts, if necessary) for each StackMaster TX12 to be installed.

2. Carefully align the StackMaster TX12 between the 19-inch rack mounting rails at the installation position.

3. Install two screws through right front bracket and two screws through left front bracket, using clip nuts if necessary.

9 StackMaster™ TX12 100BASE-TX 12-Port Stackable Hub 6