TEW-711BR
TRENDnet User’s Guide
How to allow remote access to your router management page
Management > Remote Management
You may want to make changes to your router from a remote location such at your office or another location while away from your home.
1. Log into your router management page (see “How to access your router management page” on page 11).
2.Click on Management, and click on Remote Management.
3.Under the HTTP section, click Enabled.
∙Port– It is recommended to leave this setting as 8080.
Note: If you have configured port 8080 for another configuration section such as virtual server or special application, please change the port to use.
(Recommended port range
∙Remote IP Range – It is recommended to leave this setting as *, to allow remote access from anywhere on the Internet.
Note: You can enter a specific range of Internet IP addresses that are allowed to access your router management page, all others will be denied.
4. To save changes, click Apply.
Advanced Router Setup
How to expose a device on your network to the Internet
Access > DMZ
You may want to expose a specific computer or device on your network to the Internet to allow anyone to access it. Your router includes the DMZ (demilitarized zone) feature that makes all the ports and services available on the WAN/Internet side of the router and forwards them to a single IP address (computer or network device) on your network. The DMZ feature is an easy way of allowing access from the Internet however, it is also very insecure method.
It is strongly recommended to use virtual server (also called port forwarding, see “How to allow access using virtual server” on page 31) instead, to allow access to your computers or network devices from the Internet.
1.Make sure to configure your computer or network device to use a static IP address or you can use the DHCP reservation feature (see “How to setup DHCP reservation” on page 17).
2.Log into your router management page (see “How to access your router management page” on page 11).
3.Click on Access, and click on DMZ.
4.Next to DMZ Enable, click Enabled.
5.Next to DMZ Host IP, enter the IP address you assigned to the computer or network device to expose to the Internet.
6.To save changes, click Apply.
© Copyright 2011 TRENDnet. All Rights Reserved. | 21 |
