Shear Bolts |
|
|
Carriage Bolt | Flange Lock Nut | Shave Plate |
|
Figure 17
•Reassemble the new shave plate, making sure heads of carriage bolts are to the inside of the housing. Tighten securely.
Replacing Belts
To remove and replace either the auger belt or the drive belt, follow the steps below and then proceed to the specific steps listed under respective
•Disconnect the chute directional control at the chute assembly base by removing the hairpin clip and the flat washer. See Figure 18.
•Remove the plastic belt cover, located near the engine, by removing the three
Hairpin | Flat | Belt Cover Screws(3) | Belt Cover | |
Clip | Washer |
|
|
|
|
|
|
| |
|
|
| Upper Bolt | |
|
| Shoulder Bolt | (remove) | |
|
| (do not remove) |
|
|
Figure 18
•Remove the large shoulder bolt and washer on the left hand side of the engine pulley. See Figure 19.
Engine Pulley |
Shoulder Bolt |
Figure 19
Auger Belt
•Remove the cotter pin and washer from the ferrule in order to disconnect the auger idler rod from the brake bracket assembly. See Figure 20.
Engine |
|
Pulley | Auger Control |
| |
Auger Idler | Belt |
| |
Rod |
|
Ferrule |
|
Brake Bracket |
|
Assembly | Cable Roller |
| |
Z Fitting | Guide |
|
Figure 20
•Slip the auger control belt (the front belt) off the engine pulley.
•Pull the brake bracket assembly towards the cable guide roller and unhook the auger cable “Z” fitting.
•Remove the upper bolts and lock washers which secure the auger housing assembly to the frame assembly using a 9/16” wrench. See Figure 18.
•Separate the auger housing from the frame assembly by tilting the housing forward and pulling up the handles.
•Using a 1/2” wrench, remove the hex bolt and bell washer from the center of the pulley on the auger housing. Lift the brake bracket assembly out of the pulley groove and remove the pulley. Be careful not to lose the key. See Figure 21.
16
