Troy-Bilt 10530 manual Auger Control, Chute Tilt Control, Chute Directional Control, Headlights

Drive Control /	Right Wheel Steering Control
Auger Control Lock	Shift Lever
Headlights	Chute Tilt Control
	Auger Control
Fuel Tank
Discharge
Chute	Chute
	Directional Control	Recoil
Chute		Starter
		Handle
Clean-out Tool	Left Wheel Steering Control
		Electric
		Starter
	Primer	Button
		Switch
	Choke	Box
		Fuel Shut-Off Valve
		*If Equipped
	Safety Ignition	Closed
Auger	Key
Skid Shoe	Throttle Control	Open

Figure 8

Auger Control Clean-out Tool

The auger control is located on the left handle. Squeeze the auger control to engage the augers. Release to stop the snow throwing action. The drive control must also be released in order to stop the auger.

IMPORTANT: Refer to Auger Control Test on page 10 prior to operating your snow thrower. Read and follow all instructions carefully and perform all adjustments to verify your snow thrower is operating safely and properly.

Chute Tilt Control

The distance snow is thrown can be changed by adjusting the angle of the upper chute. Move the chute tilt control forward to decrease the distance, and backwards to increase distance. See Figure 8.

Chute Directional Control

The chute directional control is located on left hand side of the snow thrower.To change the direction which snow is thrown, rotate chute directional control as follows:

•Clockwise to discharge to the left.

•Counterclockwise to discharge to the right.

Headlights

When properly connected, both headlights illuminate whenever the engine is running.

WARNING: Never use your hand to clear a clogged chute. Shut off engine and remain behind handles until all moving parts have stopped before unclogging. Use the clean-out tool or a stick to unclog.

This item, along with the electric cord, is fastened with a cable tie to the rear of the auger housing at the factory. Cut the cable tie and remove the electric cord before operating the snow thrower.

The clean-out tool (see Figure 8) is designed to clear a clogged chute. Refer to page 11 for detailed instructions on how to properly use the clean-out tool.

Wheel Steering Controls

The left and right wheel steering controls are located on the underside of the handles and are used to assist in steering the snow thrower.

•Squeeze the right wheel steering control when turning right; squeeze the left control when turning left.

•Operate the snow thrower in open areas until becoming familiar with these controls.

8