3.Pull the belt off Pulley B.
4.Replace in the opposite order.
Replacing Cogged Belt
See your authorized service dealer to have the cogged belt replaced or phone Customer Support as instructed on page 2 for information on ordering a Service Manual.
Replacing Auger Paddles
The snow thrower auger’s rubber paddles are subject to wear and should be replaced if any signs of excessive wear are present.
1.Remove the existing rubber paddles by unthreading the hex washer screws and nuts that secure them to the auger.
See Figure
Figure
2.Secure the replacement rubber paddles to the auger using the hardware removed earlier.
Replacing Wheels
1.Unscrew the screws on each side of the wheel shaft. See Figure
NOTE: It may help to use a clamp to hold the wheel shaft in place while removing the screws.
Figure
2.Replace the roller wheels with the hardware removed earlier.
16
Section 7— Service
