Troy-Bilt 2690 4— C, Primer, Muffler, Warning, Gas Cap, Oil Fill, Oil Drain, Ignition Key, Choke Control, Throttle Control, Electric Starter Outlet, Electric Starter Button

Oil Fill

Engine oil level can be checked and oil added through the oil fill.

Oil Drain

Engine oil can be drained through the oil drain.

Muffler

Engine exhaust exists the engine via the muffler.

Warning! Do not touch the muffler while the engine is hot or running. The muffler is hot and can cause a severe burn.

Primer

Pressing the primer forces fuel directly into the engine’s carburetor to aid in cold-weather starting.

Throttle Control

The throttle control is located on the engine. It regulates the speed of the engine and will shut off the engine when pushed into the stop position.

Electric Starter Outlet

Requires the use of a three-prong outdoor extension cord and a 120V power source/wall outlet.

NOTE: The electric starter is mounted to the plastic shroud and is shown in Fig. 4-1 attached to the engine for easier reference.

Choke Control

The choke control is found on the rear fo the engine and is activated by rotating the knob clockwise. Activating the choke control closes the choke plate on the carburetor and aids in starting the engine.

RUN

MARCHE

CHOKE

VOLET DE

DÉPART

Electric Starter Button

Pressing the electric starter button engages the engine’s electric starter when plugged into a 120V power source.

Gas Cap

Unthread the gas cap to add gasoline to the fuel tank.

Ignition Key

The safety ignition key must be fully inserted and snapped in place before the engine will start. Remove the ignition key to prevent any unauthorized use of the equipment.

NOTE: Do NOT attempt to turn the key.

14Section 4— Controls and Features