2.Place chute assembly onto chute base and secure chute control assembly to chute support bracket with clevis pin and cotter pin removed earlier. See See Fig. 3-3.

4.Check that all cables are properly routed through the cable guide on top of the engine. See Fig. 3-5.

Figure 3-3

3.Finish securing chute control assembly to chute support bracket with wing nut and hex screw removed earlier.

See Fig. 3-4.

Figure 3-4

Figure 3-5

Set-Up

Shear Pins

A pair of replacement auger shear pins and bow tie cotter pins are included with your snow thrower. Store them in your snow thrower’s dash panel until needed. See Fig. 3-6.

Figure 3-6

8Section 2— Assembly & Set-Up