Recoil Starter

To Engage Drive

Caution! Do not pull the starter handle while the engine running.

WARNING! To avoid unsupervised engine operation, never leave the engine unattended while running. Turn the engine off after use and remove ignition key

1.Insert the ignition key fully into the slot, Fig. 5-1. Make sure it snaps into place. DO NOT turn the ignition key. The engine cannot start unless the key is inserted into the ignition switch.

2.Move the throttle control to the FAST (rabbit) position.

3.Move the choke to the ON position (cold engine start). If the engine is warm, place the choke in the OFF position.

4.Push the primer three to five (3-5) times, making sure to cover the vent hole when pushing. If the engine is warm, push the primer only once. Always cover the vent hole when pushing. Cool weather may require priming to be repeated.

5.Pull gently on the starter handle until it begins to resist, then pull quickly and forcefully to overcome the compression. Do not release the handle and allow it to snap back. Return the rope SLOWLY to the original position.

If required, repeat this step.

warning! Rapid retraction of the starter cord (kickback) will pull your hand and arm toward engine faster than you can let go. Broken bones, fractures, bruises or sprains could result.

6.As the engine warms, slowly rotate the choke control to the

OFF position. If the engine falters, restart the engine and run with the choke at the half-choke position for a short period of time, and then slowly rotate the choke into OFF position.

Stopping the Engine

WARNING! To avoid unsupervised engine operation, never leave the machine unattended with the engine running. Turn the engine off after use and remove the ignition key

Run the engine for a few minutes before stopping to help dry off any moisture on the engine.

1.Move the throttle control to the STOP position.

2.Remove the ignition key. Removing the key will reduce the possibility of any unauthorized starting of the engine while the equipment is not in use. Keep the key in a safe place.

The engine cannot start without the ignition key.

3.Wipe any moisture away from the controls on the engine.

1.With the throttle control in the Fast (rabbit) position, move the shift lever into one of the six forward (F) positions or two reverse (R) positions. Select a speed appropriate for the snow conditions and a pace you are comfortable with.

2.Squeeze the drive control against the handle and the snow thrower will move. Release it and the drive motion will stop.

To Engage Augers

1.To engage the augers and start throwing snow, squeeze the auger control against the left handle. Release to stop the augers.

16Section 5— Operation