![](/images/new-backgrounds/1112290/11229047x1.webp)
ENGINE AND SNOWTHROWER MAINTENANCE
3.Remove the two (each side) flange screws (Figure
Figure
4.Slowly pivot the rear half of the snowthrower back. Rest the handlebars on a stable object.
5.Take the auger drive belt (Figure
6.Loosen the bolts that attach the belt guides to the front of the chassis below the transmission pulley. Turn these belt guides to give you room to take the wheel drive belt off the transmission pulley.
7.You may have to loosen the bolt that secures the engine pulley belt guide (Figure
8.Take the wheel drive belt off the transmission pulley and engine wheel drive pulley.
To install the wheel drive belt:
1.Place the wheel drive belt on the engine wheel drive pulley and transmission pulley.
2.If you had to loosen the bolt that secures the engine pulley belt guide (Figure
3.Rotate one of the two belt guides that is below the transmission pulley so that its "leg" is
tighten the bolt that holds the belt guide in place. Repeat this step for the remaining belt guide.
4.Retighten bolt that attaches belt guide (Figure
5.Move the rear half of the snowthrower close to the front half. Place the auger drive belt onto the engine auger drive pulley (Figure
6.Move the snowthrower halves together. Align the four attachment holes (two in each side of the frame). Loosely install the four screws (Figure
7.Reinstall the worm gear and support (Figure
8.Adjust the wheel drive cable. See "Wheel Drive Cable Adjustment".
9.Reinstall the belt cover on the snowthrower.
Auger Drive Cable Adjustment
CAUTION Before adjusting the auger drive cable, shut the engine off, allow it to cool, disconnect the spark plug wire and prevent it from touching the spark plug, and remove the engine ignition key.
Failure to follow this instruction could result in personal injury or property damage.
Figure
22