![](/images/new-backgrounds/1112290/11229019x1.webp)
EASY ASSEMBLY
)
B~
Figure
Step 1: Attach the Handlebars.
1.Remove the four loosely installed
2.Place the lower ends of the handlebar assembly on the outside of the upper rear corner of the frame as shown in Figure
3.Loosely install a
4.Repeat the previous two steps for the right side of the lower handlebars.
5.Evenly tighten all four screws.
6.Use the two
Step 2: Connect the Ignition Ground Wires
1.Run the black ignition ground wire down the left- hand handlebar tube as shown in Figure
2.Plug the connector at the lower end of the black ignition ground wire into the terminal beneath the Engine Control Lever. See Figure
3.Attach the black ground wire
to the lower left handlebar
with the two tie straps. See N Figure
Figure
8