True Manufacturing Company TCGDZ-50 Temperature Control Adjustment for High Altitude only, Terms

True Food Service Equipment, Inc.

MAINTENANCE, CARE & CLEANING

TEMPERATURE CONTROL ADJUSTMENT FOR HIGH ALTITUDE ONLY!

TERMS:		NOTE
•	Cut-out - Temperature sensed by the controller	Mechanical temperature controllers are affected
	that shuts the compressor off.	when functioning at high altitude. The Cut-in and
•	Cut-in - Temperature sensed by the controller	cut-out temperatures will be colder than when the
		controller functions closer to sea level.
	that turns the compressor on.
TOOLS REQUIRED:		D. For high elevation installations, it may be nec-
		essary to "warm-up" the set points. To make
•	Phillips head screwdriver	the adjustment, insert the appropriate tool in
•	5/64" or 2 mm Allen wrench	each adjustment screw and turn 1/4 of a revo-
• T-7 Torx wrench
		lution clockwise (to the right). This procedure
A. Unplug or disconnect power to the cabinet.		will adjust both the cut-in and cut-out about
		2°F warmer.
B. Remove the screws that secure the tempera-
		E. Make sure to reconnect the pink wire to prop-
	ture control to the inset box, lower right, rear	er spade terminal when reinstalling.

of cabinet.

C.Pull out gently from cabinet.

DANFOSS TEMPERATURE CONTROL

Compressor Connection (pink)

4

3

Cut-out Adjustment Screw Allen (5/64" or 2 mm) (clockwise for warmer)

Cut-in Adjustment Screw Torx (T-7)

(clockwise for warmer)

Compressor Connection (pink)

(double terminal)

To wire temperature control:

connect one pink wire (either one) to terminal 3 and the other pink wire to terminal 4.

14 www.truemfg.com 14