Audio Advantage Amigo

2-speakers (Stereo)

Select this configuration when using powered stereo speakers. The speakers may be connected to the Headphone – S/PDIF Output.

Using a Headset with Microphone

Insert the headset’s mic jack (sometimes colored pink) into the Mic Input and the line jack (sometimes colored green) into the Headphone-S/PDIF Output. Set the speaker configuration in the Control Panel Speakers Tab to Headphones. Adjust the mic level with the Control Panel Mixer Tab.

The Amigo is a perfect companion for Internet phone or online chat when used with this headset.

When inserted into the USB port, the Amigo automatically becomes the default headset and microphone interface, allowing you to listen and speak using the headset and mic. When you’re done, unplugging the Amigo from the USB port returns your PC or laptop to its previous audio configuration.

Testing the Speaker Configuration

After selecting the speaker configuration to match your speaker system, you can check if the speakers are properly connected by clicking on the speaker icon to play a test signal on that speaker.

The buttons at the bottom of the speaker icon section, labeled Test and Loop, operate as follows:

ƒTest: When this button is clicked, the test signal automatically advances to the next speaker so that both speakers play once.

ƒLoop: When this button is enabled, if the Test button is clicked, the test signal will continuously play in sequential order on both speakers until the Test button is turned off. If the Loop button is enabled with the Test button off, clicking a speaker

will repetitively play the test signal on that speaker until the Loop button is turned off.

Page 23