Tyan Computer B5102, GX21 manual Super IO Controller, Onboard FDC Controller, Onboard Serial Port 1

Super IO Controller

Phoenix – AwardBIOS CMOS Setup Utility

Super IO Device

Onboard FDC Controller		[Enabled]
Onboard Serial Port 1		[3F8	/ IRQ4]
Onboard Serial Port 2		[2F8	/ IRQ3]
UART Mode Select		[Normal]
RxD, TxD	Active	[Hi, Lo]
IR Transmission Delay		[Enabled]
UR2 Duplex Mode		[Half]
Onboard Parallel Port		[378	/ IRQ7]
Parallel	Port Mode	[SPP]
EPP Mode	Select	[EPP1.7]
ECP Mode	Use DMA	[3]

Item Help

_________________________

Menu Level XX

↑↓←→ : Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help

F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults

Onboard FDC Controller

Set this option to enabled if your system has a floppy disk controller (FDC) installed on the system board and you wish to use it. If you install an add-in FDC or if the system has no floppy drive, set this option to disabled. The choices are:

Enabled / Disabled

Onboard Serial Port 1 / 2

To use the first and second serial ports on the system, select an address and corresponding interrupt for the first and sec- ond serial ports. The possible values are:

3F8/IRQ4 / 2E8/IRQ3 / 3E8/IRQ4 / 2F8/IRQ3 / Disabled / Auto

UART Mode Select

This option allows the second serial port to be used either as a normal serial port or as an infrared port. Select Normal for a normal serial port. The choices are:

Normal / IrDA and ASKIR

76