Revision A

You have to press this button the number of times required for displaying the screen below:

4.0 cmH2O

vP

The pressure value can then be changed by using the ON/OFF and Ramp keys.

The ramp function enables you to make the rise in pressure progressive. Thus, the pressure level is low at the start of the night to help you to fall asleep. You can also use this function if you have to get up during the night and have difficulty going back to sleep. The pressure rise time up to the final pressure is prescribed by your medical team and the setting carried out by your service provider is between 0 (no progressive rise) and 30 minutes in 5-minute increments. The ramp may have been preset to 0 according to your medical team’s prescription. In this case, the ramp function is disabled and pressing the Ramp button on the front panel of the device has no effect. (Refer to reference 3 in Figure 2, page 5).

1.To start the ramp, just press the Ramp button when the device is on. The pressure will fall to a lower value, as previously described, then increase progressively up to the prescribed pressure level, so as not to wake you. The device will run normally, delivering a treatment pressure throughout the night unless you press the Ramp button again.

2.To end the ramp, press the Ramp button again and the function will be disabled. To reset the ramp, press the ramp function again (the ramp indicator lights up when this is activated).

Pressure

Pmax

Set pressure

Starting ramp pressure

Pmin

Pressure rise time

Pressure rise time

Time

Resetting the ramp

Start-up and RAMP function active

Figure 11 – Changes in pressure over time

when activating the ramp function

GoodKnight 420G - Patient Manual

13