Revision A

Checking the components

In order to be able to use the GoodKnight 420G with its specific electrical power supply, you must have at least the following items:

A patient tubing.

A nasal mask (often called an “ interface ”) with all its fastening accessories as specified in the instructions for using this mask.

In addition to these accessories, your doctor could have prescribed the use of a humidifier. In this case, check that you have all the accessories for this humidifier specified in its operating instructions.

In the case of an additional oxygen supply, you must also have an adaptor (only in the case where the oxygen supply is not fitted directly onto the mask). See the chapter “Fitting an oxygen adaptor”. (See page 8).

Carefully check the device and each accessory. Check especially that the hoses are not damaged and that the mask does not have any cracks or distortion in the mask housing or seal (part of the mask coming in contact with the face).

Carefully check the device and the specific power supply module and verify that there is no obvious fault. Plug the device to the mains using its power supply module, referring to steps 4 and 5 of the chapter “Standard installation”. (See page 7).

The type of the device is displayed for a few seconds then the following standby screen showing the hour (the value displayed is given as example):

9:31 Ÿ

Standby Indicator

(the two points are blinking).

Figure 1 – View of the display when the device is in standby mode

If the device was disconnected while the motor was running, the screen displays the pressure. The device shows the same adjustments as at the time of the power supply cord disconnection and is set on the pressure used at the time of disconnection.

Start the device by pressing the ON/OFF button. (See reference 4 in Figure 2, page 5). The blower should start up and the noise should be regular.

Stop the device by pressing the ON/OFF button and unplug the power supply lead from the mains.

WARNING

In the event of problems or if you discover any anomaly, do not start the treatment and contact your home service provider.

GoodKnight 420G - Patient manual

3