U-Line manual Initial Startup, Interior Lighting, Operation, 1115WC, 1175WC

5 Operation

ULIN_0126_A

Figure 2

IMPORTANT

Proper air flow (Figure 2) is required for your unit to operate at its highest efficiently. A grille, located in the base of the unit, must not be blocked at any time, or your unit will not perform as expected.

Initial Startup

All U-Line units are shipped with controls that are preset. No initial adjustments are required.

IMPORTANT

U-Line recommends the unit be allowed to run overnight prior to loading with product.

1

ULIN_0180_A

Figure 3

To turn the unit on or off, press and hold the ON/OFF button (Figure 3, 1) for approximately ten seconds and release. The display will show the unit set-point temperature when turned on and display OFF when the unit is off.

Interior Lighting

The interior of the cabinet can be illuminated whenever the door is opened or remained darkened for a 36-hour period (blackout/Sabbath mode [not Star K certified]).

1	2	3	4	5
			ULIN_0181_A

Figure 4

The LIGHT button (Figure 4, 1) on the control panel is used to change the lighting functions.

To turn the lights and display off for a preset 36-hour interval (blackout/Sabbath mode [not Star K certified]):

1.Press and hold the LIGHT button (Figure 4, 1) for ten seconds and release (the °F symbol will flash briefly at the end of the ten second period).

2.The interior light and control display (Figure 4, 3) will go dark for the next 36 hours.

NOTE: Although the display will not be visible, the temperature controls in the unit remain active, and the interior temperature will be maintained.

3.To exit the blackout/Sabbath mode (not Star K certified) before the 36-hour period, repeat Step 1.

Another lighting mode is available. To illuminate the interior of the cabinet for a timed four-hour period:

1.Press and release the LIGHT button (Figure 4, 1) to switch from door-operated lighting control to the timed four hour lighting period (the °F symbol will flash briefly after the LIGHT button is pressed).

2.At the end of the four-hour period, the light will turn OFF and door-operated lighting control will resume.

3.To exit the timed lighting control before the end of the four-hour period, repeat Step 1.

1115WC, 1175WC 7