U-Line 1175WC, 1115WC manual Invert

7.Relocate plastic spacer/bushing (Figure 22) on bottom of door to opposite side, and place door on bottom hinge pin. Clean out bushing hole in door bottom with a screwdriver if necessary.

	Hinge
Plastic		Plastic
Plug Hole		Plug Hole
	Screw
Right Side		Left Side
Door Swing		Door Swing
Right Side	Invert	Invert
Hinge	Screw	Hinge
		ULIN_0142_A

Figure 23

8.Remove plastic hole plug (Figure 23) from door handle and relocate on opposite side.

9.Remove pivot screw from top hinge, invert screw and reinstall pivot screw in top hinge. See Figure 26.

ULIN_0144_A

Figure 24

10.Remove three plastic screw plugs (Figure 24) from hinge holes, top of cabinet, opposite side. Be careful not to scratch cabinet.

11.Place door on lower hinge pin. Invert and install upper hinge on door.

ULIN_0145_A

Figure 25

12.Fasten upper hinge to unit (three screws) (Figure 25). Partially tighten screws.

13.Adjust door to assure proper seal. Tighten upper and lower hinge screws securely.

14.Replace three plastic plugs removed in Step 10 into holes on top of unit. Replace screws in holes in bottom of unit on opposite side.

15.Replace the grille and grille cap. Be sure to place grille cap on opposite side of unit from where it was originally.

Model 1175WC

To reverse the door, perform the following:

1. Remove the grille (two screws).

ULIN

Figure 26

2.Remove top hinge from cabinet (four screws) (Figure 26). Hold door to keep it from falling.

3.Lift the door off the bottom hinge.

ULIN_0105_A

Figure 27

4.Remove four plastic plugs (Figure 27) in hinge holes, top of cabinet, opposite side. Be careful not to scratch cabinet.

1115WC, 1175WC 17