U-Line 1175WC, 1115WC manual Leveling, Door Alignment Check and Adjustment

4.Clean the condenser coil (Figure 13, 2) using a soft brush with a “combing” action or vacuum cleaner. Do not touch the condenser coil.

	1
	2
3	ULIN_0159_A

Figure 14

5.Place the hook-hinge (Figure 14, 1) located on the rear bottom side of the grille onto the front lip (Figure 14, 2) of the unit base. Swing the grille up into position, and align the screw holes on the grille to the grille screw hole on the cabinet.

6.Secure, but do not overtighten both grille screws (Figure 14, 3).

7.Reconnect power to unit.

Leveling

It is important that units equipped with adjustable feet are level, for proper door and ice maker (if equipped) operation.

To level units with adjustable feet:

1

ULIN_0183_A

Figure 15

1.Use a level to check the levelness of the unit from front to back and from side to side. Level should be placed along top edge and side edge as shown (Figure 15).

1

ULIN_0042_A

Figure 16

2.If the unit is not level, adjust the feet on the corners of the unit as necessary (Figure 16).

3.Check the levelness after each adjustment and repeat the previous steps until the unit is level.

Door Alignment Check and Adjustment

IMPORTANT

Properly aligned, the door’s gasket should be firmly in contact with the cabinet all the way around the door (no gaps). Carefully examine the door’s gasket to assure that it is firmly in contact with the cabinet. Also make sure the door gasket is not pinched on the hinge side of the door.

ULIN_0143_A

Figure 17

1.Loosen (do not remove) top (Figure 17) and bottom hinge screws.

2.Align door squarely with cabinet.

3.Make sure gasket is firmly in contact with cabinet all the way around the door (no gaps).

4.Tighten bottom hinge screws.

5.Tighten top hinge screws.

1115WC, 1175WC 15